Assembly
unobstructed along the bottom of the base plate. Make sure that
the clamping station with the base plate is not located in the water
bath. For this reason, make sure the coolant in the machine
compartment has completely drained when actuating the air
connections.
NSL3-V1 clamping stations with turbo function
For clamping stations with turbo function type NSL3-V1, piston
chamber ventilation takes place alternately at one of the two free
air connections. The air connections or connected supply lines
must have a ventilation option for this reason. When a clamping
station NSL3-V1 with turbo connection is used, the spring-actuated
locking procedure at the quick-change pallet modules is actively
supported with air pressure. This results in a higher pull down
force. The increase in the pull down force on the clamping
modules is achieved with a pressure pulse at the air connection.
After actuation of the turbo function, the compressed air supply
can be disconnected again.
Connecting hose lines
Choosing the minimum cross section for the hose line depends on
the number of quick-change pallet modules installed inside one
clamping station or in several clamping stations actuated with
shared hose lines. Then, supply lines with the following minimum
cross sections must be used.
Number of clamping modules
installed
min. nominal hose width (hose
inner diameter)
1
4 mm
2, 3, 4
6 mm
5
8 mm
When decoupling hose lines, the pneumatic plug-in connection or
the sealing nipple must be protected against the ingress of dirt or
coolant. The sealing nipple comes with a plastic cover plug. If,
however, the supplied pneumatic plug-in connection is installed, a
suitable seal must be provided via an accessory on the plug
connection or the hose line.
4.3.1 NSL3 150-V1-T
The clamping station can be clamped directly onto the machine
table via screws. Permitted areas for appropriate bore holes can
be found in the attached bore hole drawings. Optionally, BRR 50
clamp banks can be purchased. There are four alignment grooves
on the bottom of the clamping station to mount T-nuts used for
aligning the clamping station. These allow for precise alignment
along an alignment groove. The clamping station is equipped with
a quick-change pallet module with two fitting grooves for the
21
03.00 | NSL3 | VERO-S quick-change pallet system | en | 1155408
