SCHUNK VERO-S NSL mikro 50-13, Перевод оригинального руководства по эксплуатации

Страница: 20 / 37

Assembly
20 01.00|NSL mikro 50-13 1425873|en
Compliance
For the sake of conformity, clamping pins with positioning
accuracy in one direction (SPB mikro 10) should be used for
clamping modules within a clamping station or multiple interlinked
clamping stations that are more than 160 mm apart or that do not
show a positioning tolerance of ±0.01 mm. For the clamping areas
that are not intended for alignment of the device or pallet,
clamping pins with centering clearance (SPC mikro 10) can be
used.
(

4.4, Page 25)
Even height of the clamping modules
Even height of the clamping modules within a clamping station is
only ensured when in a clamped state. The clamping station is to
be fastened with the BRR mikro 17 clamp blanks included in the
scope of delivery. The clamping station must be fastened on the
machine table with all clamp blanks provided to ensure safe
mounting. The clamp blanks must be fastened with adequately
dimensioned fastening screws in accordance with DIN EN ISO 4762
of thread size M4 or above. The prescribed arrangement for the
clamp blanks can be found in the following clamping diagram.
CAUTION
The height of the modules will only be even once the clamping
station has been properly mounted on the machine table.
For the arrangement of the BRR mikro 17 clamps see the
"Clamping range" illustration.