SCHUNK SRH-plus-D, Сборка и руководство по эксплуатации

Страница: 27 / 56

Assembly and settings
CAUTION
Material damage due to incorrect settings!
By incorrect setting of the swivel angle parts can come loose and
the product may be damaged.
•
Only trained stuff may set the swivel angle.
•
Before setting the swivel angle release pressure.
1. Loosen screw of the limiting sleeve (6) approx. one revolution.
2. Actuate air connection
B (4).
3. Open the exhaust throttle valve at air connection A (3) until
the swivel head (5) starts to move.
✓
Swivel head swivels towards the end position.
4. Set the desired end position by twisting the stop B (2).
5. Check end position.
✓
To do this, ventilate air connection B (4) and actuate it
again, if necessary adjust end position.
6. Tighten screw (6).
7. Loosen screw (7) by approx. one revolution.
8. Ventilate air connection
B (4) and actuate air connection A (3).
9. Open the exhaust throttle valve at air connection B (4) until
the swivel head (5) starts to move.
✓
Swivel head swivels towards the end position.
10. Set the desired end position by twisting the stop A (1).
11. Check end position.
✓
To do this, ventilate air connection A (3) and actuate it
again, if necessary adjust end position.
12. Tighten screw (7).
✓
Tightening torque: SRH-plus-D 20-30: 1.2 Nm / SRH-plus-D
35-60: 2.1 Nm
27 03.00 | SRH-plus-D | Assembly and Operating Manual | en | 1424337