Assembly and settings
02.01|RST-P 060 / 087|en
19
The load occurring during operation is mounted onto the mod-
ule.
The permissible swiveling time (
☞
catalog data) is set.
NOTE
If the counter-plate is loosened, compressed air can escape to a
small extent.
1 Slightly undo the screws (51) to undo the counter-plate (15).
2 Turn the dampers to the desired position.
3 Tighten screws (51).
4 Test dampening during operation, correct swiveling time if ne-
cessary and readjust the setting of the dampers.
The damper is set correctly if the device reaches its end posi-
tion swiftly without any mechanical impact.
The dampening of the reverse stroke through the elastomer
damper in the back stop (17) in versions L / R is set indepen-
dently of the load and swiveling time.
NOTE
If the counter-plate is loosened, compressed air can escape to a
small extent.
1 Slightly undo the screws (51) to undo the counter-plate (15).
2 Turn the back stop (17) to the desired position.
3 Tighten screws (51).
4 Check the dampening in operation and correct the setting if
necessary.
The elastomer damper is set correctly if the piston reaches its
end position during reverse stroke without mechanical impact.
Setting of the shock
absorbers
Setting the back stop