Maintenance and care
44
03.01/3-Finger Centric Gripper PZN-plus/en
B
A
100
45
25
103
104
3 8
101
10
Fig. 17
Dimensions of the mounting device
1 Fit device 1 (100 with the screws (101) and grease the centring
bore with Renolit HTL 2.
2 Insert the springs (25) into the housing through the centring
bore.
3 Place the cylinder piston (10) on the centring bore and press it
evenly into the bore by hand (CAUTION: do not tilt it) until the
cylinder piston comes up against the spring.
4 Insert the screw (45) in the piston.
5 Position device 2 (103) in place and screw it evenly with the
screws (104) to device 1 (100).
6 Insert screw (45) and screw it into the piston (3 / 8).
7 Remove the devices, fit the seals (32 and 34) and the cover (9)
Assembly using
2 devices
for PZN-plus 125 -380
