Assembly
32
08.00 | PZN-plus | Assembly and Operating Manual | en | 0389374
NOTE
If the switching position cannot be queried, it may be that the
alignment of the control cam has to be changed,
Turn control
cam
[
}
25].
Position "Gripper closed" or "Part gripped (O.D. gripping)"
Ø
Slide the sensor 3 (1) to the stop into the bracket (2).
Ø
Tighten the screw (3) on the bracket (2).
Tightening torque: 0.2 Nm
Ø
Close gripper or grip part.
Ø
Undo the screw (4).
Ø
Turn the screw (5) to push the position of the control cam (6).
✓
Slide control cam (6) outwards until the sensor 3 (1) no
longer responds.
Move the control cam (6) back towards the inside until the
sensor 3 (1) begins to switch.
Ø
Tighten screw (4) and in doing so press the control cam in the
direction of the gripper fingers.
NOTICE! The control cam may
tilt in the guide if it has not been tightened properly.
✓
Switching point is set.
Ø
Bring product into the "Gripper closed" or "Part gripped" posi-
tion and test the function.
NOTE
If the switching position cannot be queried, it may be that the
alignment of the control cam has to be changed,
Turn control
cam
[
}
25].
Variant Dust-tight:
Screw in set-screw into the side cover.
5.3.10 Mounting inductive proximity switch IN 80
NOTICE
Blockade of the gripper after setting or replacing of the switch-
ing cam!
The switching cam can be tilt in the guide, if it was not fixed ex-
actly in the base jaw.
•
Apply the switching cam in the direction of the base jaw, so
that the cam does not contact the housing of the gripper.