SCHUNK NSL3 turn 450-3, Сборка и руководство по эксплуатации

Страница: 30 / 54

Assembly
30 02.00|NSL3 turn 450-3, 450-3-Z, 570-5, 570-5-Z |en
NSL3 turn-Z
The NSL3 turn-Z clamping station, compared with the basic
version, is also equipped with a centering taper as an alignment
element in the turning center.
The centering taper achieves the highest centering and run-out
accuracy and replaces the SPA clamping pin.
Here, the alignment function is divided between the centering
taper and one of the built-in VERO-S quick-change pallet modules.
The two different clamping pin types
SPB, SPC are needed (see Fig.
"NSL3 turn 450-3-Z" and "NSL3 turn 570-5-Z" as well as the
chapter "Clamping pins SPA 40, SPB 40, SPC 40"
(

4.5, Page 33) ).
The central positioning of the clamping pallet is achieved with the
centering taper. In a VERO-S quick-change pallet module, the
clamping pin is fitted with positioning accuracy in a direction
SPB
40 , which ensures the angular alignment of the clamping pallet.
Attention must be paid to the angle-oriented positioning of the
sword-shaped alignment surfaces. The supporting alignment
surfaces on the
SPB 40 must be oriented parallel to the centering
taper so that a length offset can be balanced. All the other
clamping areas are fitted with clamping pins with centering
clearance
SPC 40 to prevent over-determination of the interface
position deviation.
For the application and installation of the centering sleeve, which
is available as an accessory, see chapter "Centering sleeve for
clamping pallets"
(

4.6, Page 37)
For the required parts, see table in the chapter "Accessories for
clamping pallets".
(

8, Page 47)
NSL3 turn-Z with three VERO-S quick-change pallet modules and
flexible centering taper in the turning center
4.4.2