SCHUNK LDT Series, Сборка и руководство по эксплуатации

Страница: 134 / 156

Maintenance and repair work
132
05.00 | LDT | Montage- und Betriebsanleitung | en | GAS360927
7.9 Changing the magnetic strip
Changing the magnetic strip
NOTICE
The magnetic strip of the measuring system must not be
exposed to a strong magnetic field.
At about 30 gauss or more, the magnetic strip encoding will be
destroyed!
•
Keep it away from the secondary part (permanent magnets) of
the linear motor drive!
•
Pay attention to the marking on the magnetic strip. ( ☞
documentation on changing the measuring system)
Ø
Move the guided slide (1) to one side.
Ø
Unscrew the 2 magnetic strip clamps (2).
Ø
Carefully detach the magnetic strip (3 and 6) from the guide rail
(4) using a knife point and pull it off.
Ø
Carefully clean the guide rail (4) of all adhesive residue using
petroleum ether.
Ø
Slide the magnetic strip (3) underneath the guided slide (1) and
place it on the guide rail (4).
Ø
Length of the magnetic strip (3) = length of the guide rail (4) - 38 mm.
Ø
Slightly lift up one side of the magnetic strip (3) and use forceps
to remove the protective film (5) from the adhesive film.
Ø
Press the magnetic strip (3) onto the guide rail (4) while pulling
off the protective film.
Ø
When you are half-way done, slide the guided slide (1) to the
opposite side.
Ø
Slide the covering tape (6) underneath the guided slide (1) and
place it on the magnetic strip (4).