SCHUNK KSP plus-BWM Series, Сборка и руководство по эксплуатации

Страница: 34 / 55

Trouble shooting
34 04.00|1151449 KSPplus-BWM, KSP-LHplus-BWM |en
Trouble shooting
Clamping force block chuck jaws will not move
Possible cause Solution(s)
Air supply interrupted Check air supply
System pressure too low Increase system pressure according to clamping
system technical specifications
Connections mixed up Check connections and functions and connect
properly
Unused air connections not sealed Seal front or base connections using accessories
(included in scope of delivery)
Active air connections sealed Remove set-screws from sealed air connections
Piston will not move
Possible cause Solution(s)
Air is not oiled Check maintenance unit, perform maintenance
Place oiler closer to clamping system
Set required oil level
Chuck piston screw broken (overload) Send clamping system to SCHUNK for repairs or
disassemble clamping system and repair using
original SCHUNK spare parts (

8.1, Page 37)
Piston rod or piston rod screw
connection broken (overload)
Send clamping system to SCHUNK for repairs or
disassemble clamping system and repair using
original SCHUNK spare parts
Active air connections sealed Remove set-screws from sealed air connections
Jaw changing function does not operate properly
Possible cause Solution(s)
Lock bolt at changing interface not
resetting and remains depressed
Check if motion kinematics can be easily moved
and if they are damaged.
To improve movement, apply a few drops of
machine oil to the rotating joints until the
kinematics automatically reset.
Lock bolt on changing interface not
recessing
Check if motion kinematics can be easily moved
and if they are damaged.
To improve movement, apply a few drops of
machine oil to the rotating joints.
Repeat accuracy not achieved during
jaw change
Clean change interfaces and check for damage.
Replace damaged parts, if necessary.
7