Assembly
04.00|1151449 KSPplus-BWM, KSP-LHplus-BWM |en
29
are included in the accessory kit that comes with the clamping
force block.
• Do not open the connections on the front of the clamping force
block (
I, II
) or alternatively seal them with suitable dummy
plugs (M5 or G1/8").
• Insert the clamping sleeves from the accessory kit into the
centering holes on the base plate.
• Remove the seal plugs from the base plate (internal air feed-
through
III, IV
) and insert the O-rings from the accessory kit
into the recesses for the air feed-throughs.
• Mount the clamping force block onto the base plate.
NOTE:
When joining, make sure the air feed-throughs for the clamping
system and the base plate are precisely aligned.
• Screw the two parts together using the four screws (item 19)
from the accessory kit. In doing so, observe tightening
torques.
• Remove the locking screws from the pneumatic connections on
the base plate.
• Connect the diaphragm pressure switch and set the switch to
the required minimum pressure.
Inserting the changing jaws
A set of changing jaws consists of two individual jaws designed to
fit together. The jaws are marked with numbers "1" and "2".
Always insert the changing jaws on the TANDEM clamping block's
change interface with the same number in order to ensure
maximum repeat clamping accuracy.
NOTE:
Only trigger the actuating mechanism with an appropriate tool.
Only change the jaws with manual force. Do not use a hammer to
assist in changing the jaws.
The changing jaws can be changed in two ways:
First, hang the changing jaw on the hook attachment. This
connects the lateral centering bars to the base jaw.
1. Locking in place without tools:
Pull the changing jaw back and press it down to lock it into place
without tools. The spring-actuated snap-lock mechanism is
automatically triggered, locking the changing jaw to the TANDEM
clamping block.
6.4
