_________________________________________________________________________________________
schunk.com
XND.00020.002_B
–
06/2020
27
6.2
Assembly
•
Re-grease the thread of the spindle
and at the carriages using e.g. EP
high-performance grease, such as
LAGERMEISTER WHS 2002, NLGI
class 1-2.
•
Oil the running surfaces and guides of the
vice using e.g. with MOTOREX Supergliss
68 K to ISO VG 68.
•
Insert both carriages (pos. 030 and pos. 040)
into the tool body (pos. 010) up to the start of
the
X
of the spindle (pos. 020).
•
Insert the threads by turning the spindle to
the right and pressing on both carriage ends
at the same time.
Important:
Both carriages must come
together and engage in the threads at the
same time. This is imperative in order to
ensure the consistent central position of the
system.
Checking the central position
The gap between the carriage slot and the end
face of the tool body must be identical on both
sides. If this is not the case, remove the
carriages again and repeat the process.
•
Finally, fully join the carriages together so
that the inside wipers (pos. 070) are again
pressed into the carriages via the spacer
O-rings (pos. 010).
•
Re-insert the circlip (pos. 050) into the
groove of the spindle.
Important:
The high degree of precision of the KSC is achieved using a processing step while it is
mounted. The components of different vices must not be interchanged.
This is imperative in order to ensure the consistent central position of the system and
the fitting of the guide between the carriages and tool body.
