Assembly
30
03.00 | GSM-W | Assembly and operating manual | en | 389108
5.5 Adjusting the end positions
Position of the item numbers,
49].
Adjustment of the end position for elastomer dampening:
Ø
Connect connections A and B to the compressed air supply.
Ø
Actuate connections A and B alternately and allow the unit to
swivel.
Ø
Actuate connection B; the swivel unit will reach the end position
in counterclockwise direction.
Ø
Place the unit sideways on a measuring table with the air
connections facing up.
Ø
Loosen the counter nut (124) and twist the stop (83). To
increase the rotating angle range, screw out the stop, but only
up to the maximum projection dimension B. (For projection
dimensions A and B, see the following table "Total rotation
angle range").
When the rotating angle is set, tighten the counter nut (124).
Ø
Actuate connections A and B alternately and allow the unit to
swivel.
Ø
Check the set rotating angle several times. Repeat steps 5 and 6
until the desired position is reliably reached even after repeated
rotation.
Ø
To set the second end position, proceed according to steps 5 to
7, but actuate connection A.
Stepless angular adjustment with balls
For angles between "0°" and "180°" or "0°" and "90°", insert
additional steel balls (108) in the ball guide rail. The number of
steel balls required and the permissible minimum or maximum
projections of the stops, can be determined using the table "Total
rotating angle range".
