SCHUNK GSM-W 16, Сборка и руководство по эксплуатации

Страница: 44 / 56

Maintenance
44
03.00 | GSM-W | Assembly and operating manual | en | 389108
Disassembly
Ø
In order to start disassembling the DKM, the steps for
disassembly/assembly of the unit into the basic modules
Disassembly/assembly of the unit in the basic modules [ } 39]
must have been carried out.
Ø
Remove the O-rings (109) and ball guide rail DKM GSM (85)
from the housing DKM GSM.
Ø
Remove the balls (142).
Ø
Turn the screws (140) from the bushing of the gripping module
(31-34) and pull DKM GSM stop 1 (81) and the set of fitting disks
(111/112) off the bushing (44 or 46).
Ø
Pull the gripping module (31-34) from the housing DKM GSM.
Ø
For elastomer variants, proceed as follows:
Remove the stops (83) after loosening the nuts (124).
Also remove the needle rollers (122).
Ø
For shock absorber variants, continue as follows:
Remove the shock absorber (120) after loosening the nuts
(121).
Also remove the sleeves (122).
Assembly For assembly, observe the permissible tightening torques as well
as the greases and adhesives to be used;
Screw tightening torques
[
}
39] and Grease/greasing areas [
}
38].
Ø
Grease the housing DKM GSM(11) and the bushing (44 or 46) on
the running surfaces and bearings.
Ø
Grease the bearing ring (82).
Ø
Insert the bearing ring with the outer chamfer downwards into
the housing DKM GSM.
Ø
Grease the O-rings (103) and mount them into the recesses on
the bushing (44 or 46).
Ø
Insert the gripping module into the housing DKM GSM.
Ø
Match up the axial bearing seat of the bushing with the fitting
disks (111 or 112).
Ø
Place DKM stop 1 (81) onto the bushing and fasten it to the
bushing using the screws (140).
Ø
Grease the ball guide DKM (85).
Ø
Turn the bushing so that DKM stop 1 (81) is pointing 180° away
from the bore holes for dampening.
Ø
Grease the needle rollers (122) and put them into the
appropriate fits.