SCHUNK AOV-MC, Сборка и руководство по эксплуатации

Страница: 31 / 48

Troubleshooting
7.4 Sanding discs are not removed
Possible cause Corrective action
The needles are worn or damaged. Check needles for damage and replace if
necessary.
If necessary, readjust needle stroke and
reteach removal process,
Start-up [ } 20].
Compressed air lines switched. Check air supply.,
Pneumatic connection [
}
18]
Compressed air lines are not installed
optimally.
Pressure drops below minimum.
Observe the requirements for the
compressed air supply,
Technical data [
}
13].
The needle stroke is not set correctly. Readjust needle stroke.
Sanding disc and backer pad are interlocked. Add additional step in the process: sanding
over a bar or edge.
31 01.00 | AOV-MC | Assembly and Operating Manual | en | 1461420