• 7 •
Do not store the clips on the handle, clipped together, on or around metal, or clipped
12.3
to cables. The clips on the Instant Power™ are live and will produce arcing or sparking
if they come in contact with each other. To prevent accidental arcing, always keep the
clips on the storage holders when not using it to jump start a vehicle.
If the Instant Power™ is moved around the shop or transported to another location, take
12.4
care to avoid/prevent damage to the cords, clips and Instant Power™. Failure to do so
could result in personal injury or property damage.
Do not use and/or store the Instant Power™ in or on any area or
surface where damage could occur if the internal battery should unexpectedly leak acid.
IMPORTANT:
12.5
CHARGE IMMEDIATELY AFTER PURCHASE
•
KEEP FULLY CHARGED
•
Charge the Instant Power™ internal battery immediately after purchase, after every
use and every 30 days.
All batteries are affected by temperature. The ideal storage temperature is at 70 degrees
Fahrenheit. The internal battery will gradually self-discharge (lose power) over time,
especially in warm environments. Leaving the battery in a discharged state may result
in permanent battery damage. To ensure satisfactory performance and avoid permanent
damage, charge the internal battery every month.
TROUBLESHOOTING
13.
PROBLEM
POSSIBLE CAUSE
REASON/SOLUTION
The Instant Power™ won’t
jump start my car.
Clips are not making a good
connection to the battery.
The Instant Power™ battery
is not charged.
The vehicle’s battery is
defective.
Check for poor connection to
battery and frame. Make sure
connection points are clean.
Rock clips back and forth for
a better connection.
Check the battery charge
status by pressing the button
on the front of the Instant
Power™. See LeD Indicators
section of this manual.
Have the battery checked.
The Instant Power™ won’t
power my 12V device.
The 12V device is not turned
on.
The Instant Power™ battery
is not charged.
The 12V device draws more
than 15A or has a short
circuit
Turn on the 12V device.
Check the battery charge
status by pressing the button
on the front of the Instant
Power™. See LeD Indicators
section of this manual.
Disconnect the 12V device
and press the reset button
located on the back of the
Instant Power™. Try the 12V
device again. If it happens
again, replace the 12V device.
The battery in the Instant
Power™ won’t hold a
charge.
The battery is bad (will not
accept a charge).
Have the battery checked.
