• 9 •
CHARGING MODE
Charging mode lets you follow the
progress through the 8 stages of charging:
1.
Auto Voltage Detection – In this mode,
a battery is connected to the charger
and the charger is determining
whether it is a 6V or 12V battery.
2.
Desulfation – The charger has
detected an unhealthy, sulfated battery
and has begun a special process to try
to remove the sulfation and possibly
restore the battery.
3.
Soft Start – The charger has
determined the battery voltage and
gently starts to charge the battery by
slowly increasing the charging current.
4.
Bulk Mode – The majority of the
energy delivered to the battery is
done in this mode. When the charger
exits this mode, the battery will be at
approximately 80% recharged.
5.
Absorption Mode – This mode finishes
the charge of the battery by holding
the battery voltage constant until the
current tapers off.
6.
Monitoring Mode – The battery is
allowed to rest for 24 hours before
checking for a loss of charge.
7.
Float Mode – The charger is replacing
energy the battery has lost through
self-discharge or idle draw of the
attached vehicle.
8.
Maintain – The charger checks the
battery every 12 hours and puts the
charger into float mode to replenish
lost energy from the battery.
RESETTING YOUR PASSWORD
1.
In the log in screen, press
Forgot
Password
. A password reset link will
be sent to the email address
you provided during registration.
2.
Enter your new password.
3.
Reenter the new password.
4.
Click
Reset Password
to complete the
process.
14. OPERATING THE CHARGER
USING THE CHARGER
WITHOUT THE INTERNET
The charger itself is a stand-alone device
and will function as a battery charger/
maintainer without an internet connection.
However, without an internet connection,
the App will not reflect the charging
progress.
IMPORTANT:
Do not start the vehicle with
the charger connected to the AC outlet, or it
may damage the charger and your vehicle.
WARNING:
This charger is equipped with
an auto-start feature. Current is supplied
to the battery clamps before a battery is
connected, and the clamps will spark if
touched together.
NOTE: This charger is also a maintainer,
and can be left on the battery of vehicles
that are being stored.
USING THE QUICK-CONNECT
CABLE CONNECTORS
Connect any of the three output cable
assemblies to the charger in a matter of
seconds.
IMPORTANT:
Use the charger with only
one connector at a time. Do not connect
accessory cables together. This will cause
reverse polarity and damage the charger
and battery.
BATTERY CLAMP QUICK-CONNECT
Charging a Battery in the Vehicle
1.
Turn off all the vehicle’s accessories.
2.
Do not close the hood, battery
compartment, etc.
3.
Clean the battery terminals.
4.
Place the charger on a dry, non-
flammable surface, or use the
convenient hook attachment to hang
the unit safely outside the work area.
5.
Lay the AC/DC cables away from any
fan blades, belts, pulleys and other
moving parts.
