Schulze BLUEpress, Инструкция по эксплуатации

Страница: 18 / 27

4.9 Troubleshooting
Version 11.01 18
Problem Cause Debugging
Main fuse 12 A is defect Replace main fuse 12 a
The main switchs glows, but
If the main fuse is okey, check if the diode in the power supply Replace fuse 1,6A in the power supply
the display isn't
is glowing. If not the fuse or the power supply is defect or replace the power supply
the heating plate isn't heating up If the diode is glowing
Replace the electronic devices
the electronic devices are defect
The display shows ”Err.5” Thermal fuse on the heating plate is defect
Replace the thermal fuse
If you use the heating plate 400x500mm replace
both thermal fuses
The display shows ”Err.1”
Thermo couple is defect or the cables to the Check the cables to the thermo couple
thermo couple are defect or exchange the thermo couple
No connection to the heating plate Put the plug of the heating plat into the socket
The display shows ”Err.2”
The thermo couple is defect Exchange the thermo couple
The display shows ”Err.3” Resistance of the thermo couple is too low
Exchange the thermo couple
The display shows ”Err.4” Resistance of the thermo couple is too high
The display shows ”Err.6”
Power relay CRYDOM is defect Replace power relay CRYDOM
The display shows ”Err.7”
Adjustment buttons aren't working
Adjustment buttuns are defect Replace adjusment buttons
No time or temperature adjustments are possible
Temperature of the heating plate doesn't correspond to the
Malfunction of the electronic devices
Reset the electronic devices, but
Temperature on the display – Temperature too high/low first contact Walter Schulze GmbH
The press heats up very slowly – over 30 minutes
One of the tow heating elements is defect Replace the heating plate and/or send it in for repairs
one half of the plate doesn't reach the adjusted temperature
The press will not stay down Micro switch is defect
Mikroschalter einstellen oder Mikroschalter austauschen
The time is not activated The Material is to thick and so the micro switch isn't activated
The press will not close Emergency button is pressed down Pull the emergency button out
Compressed air is not connected Connect the compressed air
The press will not open Pneumatic valve is defect Replace the pneumatic valve