Schulze BLUEpress, Инструкция по эксплуатации

Страница: 17 / 27

4.7 Replacing the thermal fuse
The replacing may only be done by an authorized person.
For the replacement of the thermal fuse, the heat press
must be disconnected from the electricity and cold . Remove the cap from the
heating plate and remove the heat isolation (photo 1) . Then remove the thermal fuse (photo 2) and connect a new one (photo 3) .
Tighten it on the heating plate, put in the heat isolation and tighten the cap again. If you have the heating plate 400 x 500 mm the same
should be done with the second thermal fuse
(photo 4).
4.8 Replacing the thermo couple
The replacing may only be done by an authorized person.
For the replacement of the thermo couple the press
must be disconnected from the electricity and cold .
1. Remove the cap and take out isolation.. (photo 1)
2. Remove the thermo couple. (photo 2)
3. Remove the cable with a nipper. (photo 3)
4. Pull off the cable isolation. (photo 4)
5. Connect the cables to the new thermo couple. (photo 5)
Mind the polarity (blue to blue and red to red).
6. Tighten the thermo couple (photo 6) , lay the cables on the heat isolation and tighten the cap. (photo 7)
Version 11.01 17