SCHOLTES FL 86 AN, Руководство по эксплуатации

Страница: 28 / 76

28
GB
S w it c h ing t h e a ppl ian ce off
Disconnect your appliance from the electricity
supply before carrying out any work on it.
C l e anin g t h e a pp l ian c e
• The stainless-steel or enamel-coated external
parts as well as the rubber seals may be cleaned
using a sponge that has been soaked in
lukewarm water and neutral soap. Use specialised
products for the removal of stubborn stains. After
cleaning, rinse and dry thoroughly. Do not use
abrasive powders or corrosive substances.
• The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
• The accessories can be washed like everyday
crockery, and are even dishwasher safe.
• W e advise against spraying detergents directly
onto the control panel; instead spray the product
onto a sponge.
• Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product,
then dry thoroughly with a soft cloth. Do not use
rough abrasive material or sharp metal scrapers
as these could scratch the surface and cause the
glass to crack.
• Do not use steam equipment to clean the
appliance.
I ns p e c tin g t h e sea l s
Check the door seals around the oven periodically. If
the seals are damaged, please contact your nearest
After-sales Service Centre ( see Assistance ). W e
recommend that the oven is not used until the seals
have been replaced.
R e p l a c in g t h e l i gh t b u l b
To replace the oven light bulb:
1. Remove the glass cover using a screwdriver.
Glass door
Seal
Lamp
Oven
compartment
2. Remove the light bulb and replace it with a similar
one: W attage 15 W , cap E 14.
Replace the glass cover, making sure the seal is
positioned correctly ( see diagram ).
A u to m ati c c l e anin g u sin g t h e PY ROL Y T I C
cyc l e
During the PYROLYTIC cycle, the internal
temperature of the oven reaches 500°C. The
pyrolytic cycle is activated and burns away food
and grime residues. Dirt is literally incinerated.
Keep children away from the appliance during the
automatic cleaning cycle as surfaces may become very
hot. Particles may ignite inside the oven due to the
spontaneous combustion process. There is no cause for
concern: this process is both normal and hazard-free.
The oven advises the user when it is necessary to
perform a cleaning cycle; the display shows the text
“PYROLYTIC CYCLE recommended - START?”;
select “yes” to set the desired cleaning cycle level.
Before initiating the PYROLYTIC CYCLE:
• Remove large or coarse food residues from inside
of the oven using a damp sponge. Do not use
detergents.
• Remove all the accessories, the guide rails and
the supporting frames.
• Do not place tea towels or pot holders over the
oven handle.
If the oven is too hot, the pyrolytic cycle may not
start. W ait for the oven to cool down.
The programme may only be started once the oven
door has been closed.
To activate the PYROLYTIC cycle, press the
button followed by the
button. Select the desired
PYROLYTIC cycle level by adjusting the or
buttons. The PYROLYTIC cycle has three default
time settings which cannot be modified:
1. Economy (ECO): 1 hour
2. Normal (NOR): 1 hour and 30 minutes
3. Intensive (INT): 2 hours.
Press the “OK” button to confirm.
Press the “START/STOP” button to begin the
PYROLYTIC cycle.
C are and m aintenance