SCHOLTES B 40 L CS F Series, Руководство по эксплуатации

Страница: 17 / 52

GB
17
IE
Hobs installation
Fig .3
Securing the appliance to the cabinet
There are three different groups of appliance as far as
installation is concerned:
1- Built-in hobs to be slotted in (Class 3 - see figure 4, detail
H1).
In this case it is necessary to make a hole in the worktop
whose measurements match those of the hob. The
measurement at the side should be reduced by 2 cm so as to
ensure that 1 cm of the perimeter of the hob overlaps with and
rests on top of the supporting surface. To slot in the hob
flush with the worktop, the cut-out on this supporting surface
must be lowered (see figure 5), so that both the edge of the
hob and the seal
"X" under it can be positioned there.
Before fitting the hob to the worktop, position the seal
provided along the perimeter of the hob, as illustrated in figure
5.
fig.5
2-Built-in hobs (Class 3) with edges lower than 82 mm
(see figure 4, detail H2).
To install this type of hob, a hole
large enough to accommodate the whole lower casing of
the appliance must be made on the worktop intended to be
under the hob. Remember to leave a gap of at least 1 cm
between the lower casing and the worktop around the whole
perimeter of the appliance (the underside of the casing can,
however, touch the surface below it).
3-Sit-on hobs (Class 1) with edges higher than 82 mm (see
figure 4, detail H3).
In this case, the lower casing of the
hob does not protrude further than the edge of the
appliance. Even when the hob is resting on the worktop, it
will suffice to leave space for the gas supply tube and
electricity supply cable.
The appliance must be fixed to the kitchen cabinets using
suitable fixing accessories (these are provided) which may
vary according to the type of installation required and the
proportions of the appliance.
N.B.: to make maintenance operations more efficient, the
area around the hob must be easily accessible after it has
been installed (i.e. there are no completely shut-off
elements).
m
in.
45 mm
min.
50 m
m
82 mm
82 mm
Fig .4