SCHOLTES B 40 L CS F Series, Руководство по эксплуатации

Страница: 15 / 52

GB
15
IE
Cleaning and maintenance
To ensure long life of the appliance, it is essential to carry out
a thorough general clean frequently, taking into account that:
•
The appliance should be disconnected from the mains
supply before starting cleaning operations
.
• Avoid cleaning appliance parts when they are still warm.
•
The enamelled or chromed or glass parts must be washed
with warm water without using abrasive powders or
corrosive substances which could ruin them.
• The steel parts, especially in areas with the screen-printed
symbols, should not be cleaned with diluents or abrasive
detergents; preferably use just a soft cloth moistened with
warm water and liquid detergent for washing dishes (wipe
the cloth over the steel in the same direction as the satin-
finish).
Denatured alcohol may be used to remove stubborn dirt.
Stainless steel can be stained if it remains in contact with
agressive detergents (containing phosphorus) or water with
a high lime content. After washing the stainless steel parts
they should be rinsed and dried with a soft cloth
(washleather).
• After cleaning, some special treatments are available to
bring back the shine to steel and to prevent it from
yellowing; for this purpose, we recommend you use the
specific “special cream detergent for steel care” available
from our Assistance Centres.
• Avoid leaving acid liquids (vinegar, lemon juice, aggressive
detergents, etc.) on enamelled or painted parts.
• The removable parts of the burners should be washed
frequently with warm water and soap, making sure to remove
caked-on substance. Check that the gas outlet slits are not
clogged. Dry the burners carefully before using them again.
• Frequently clean the end part of the automatic glow plugs
of the hob.
• do not use steam cleaners to clean your oven.
Greasing the taps
As time passes, a tap may lock or become difficult to turn. In
this case it will be necessary to clean inside and replace the
grease.
This procedure must be performed by a technician authorized
by the manufacturer.