OPERATOR’S MANUAL
64
C2G rondo
Version: 27201 - H
Schmalenberger GmbH + Co. KG
D-72072 Tübingen / Germany
4.14.1
Face plate assembly installation / Concrete-tile pool
4.14.2
Face plate assembly installation / Concrete-liner pool
After connecting the air button, put on the face plate assembly (35), this allows the
pressure connection and air connection to slide into one another (refer to fig. 24). Fasten
to the clamp ring (72) with the screws (90.2).
fig. 25
C
Mounting protection film
20
Installation kit
21
Switching tube
35
Face plate assembly
90
Screw
Remove the mounting protection film (C).
After connecting the air button, put on the
face plate assembly (35), this allows the
pressure connection and air connection
to slide into one another. Fasten to the
installation kit (20) with the screws (90).
Warning!
Make sure that there is not a kink in the
switching tube (21), lay it in a loop and do
not shorten!
fig. 26
C
Mounting protection film
20
Installation kit
21
Switching tube
32
Clamp gasket
35
Face plate assembly
72
Clamp ring
74
Screw
90
Screw
Remove the mounting protection film (C).
Place the clamp gasket (32) between the
installation housing and the liner and
screw the clamp ring (72) to the
installation housing using the screws
(74). The sealing contact faces must be
clean and smooth. Now cut out the pool
liner.
Warning!
Make sure that there is not a kink in the switching tube (21), lay it in a loop and
do not shorten!
8232
8233
16
