Schiit SOL, Руководство пользователя

Страница: 5 / 16

CARTRIDGE INSTALLATION TONEARM SETUP
1 Attach the cartridge to the tonearm. Use
the nonmagnetic screws provided. Screws
should be snug but not tight, so you can
align the cartridge later.
2 Attach the tonearm wires. Be care-
ful—these wires are fragile! Sol uses the
standard wiring convention:
Red = Right Signal, Green = Right Ground
White = Left Signal, Blue = Left Ground
See Figure E for a typical cartridge installed
on the Sol Carbon Fiber Tonearm.
Once you’ve selected and installed your car-
tridge, you can proceed to tonearm setup.
1 With the stylus guard in place on the
cartridge, gently place the tonearm on the
pivot pin, as shown in Figure F. Make sure
it doesn’t overbalance and fall off; make
sure it is resting on the cueing shelf. If it is
not, loosen the counterweight and slide it in
towards the pivot until it is.
2 Plug the tonearm wire into the header on
the rear output pod of the plinth. Match the
white dot on the pod and the white dot on
the side of the tonearm wire connector. At
resting position the cueing lever should be
in the up position, as shown in Figure G.
FIGURE E
FIGURE F FIGURE G