Schiit SOL, Руководство пользователя

Страница: 4 / 16

MOTOR, PULLEY, AND BELT SETUP
2 Connect the Sol Motor and Pulley as-
sembly. Use the Sol Motor Power Cable to
connect the barrel jack on the Motor and
Pulley assembly to the OUT jack on the rear
output pod of the Sol Plinth. See Figure C
for details.
3 Connect the 16VAC Wall Wart to the IN
jack of the rear output pod of the Sol Plinth,
also as shown in Figure C.
4 Install the drive belt. The best way to do
this is by holding it at the motor pulley and
looping it around the Sol Platter, as shown
in Figure D. Use the small pulley for 33 RPM
records, and the larger pulley for 45 RPM
records.
1 Place the Sol Motor and Pulley Assembly
near the platter. The edge of the larger pul-
ley should end up about 1” away from the
edge of the platter, as shown in Figure B.
GETTING STARTED
FIGURE B FIGURE C
FIGURE D