international 21
Oil filling screw Fig. 3
Before activating remove the plastic stopper and replace
s
with the oil filling screw (14).
Always check the oil level in the sight glass(16) before
s
switching on.
The air-filter on the (15) is screwed tight on the
s
cylinder.
Putting into operation
Warning:
It is imperative to check the oil before using for the first
time!
Make sure the place of setting up is clean, dry, and
1
well vented.
Make sure the crank box is filled with oil, and the air
2
filter is fitted.
Start the compressor as described in the chapter
3
„Switching on and off the compressor“. At switching
on for the first time, let the compressor run for ten
minutes at no load with the drain valve open, so that
all the parts get well lubricated.
Warning:
As compressed air comes off the output, the out-
put may not be directed towards the operator or people
in the vicinity. The air coming off the exit may not be in-
haled. Daily check the pressure control valve.
Switching on and off the compressor, Fig. 4
Check the model plate on the compressor: 230 – 240
1
V (or 110 – 120 V).
Plug the compressor cable into a standard socket (240
2
V or 120 V) and switch the compressor on.
For switching the compressor on, lift the ON/OFF switch
3
(3) on the pressure switch cover (2).
For switching the compressor off, depress the ON/OFF
4
switch.
Operation
Fig. 5
The pressure in the tank is controlled by the pressure
1
switch under the pressure switch cover (2). When the
maximum pressure set is reached, the pressure switch
is activated and the motor switched off. The pressure
is reduced as the air is consumed by the connected
tool, until the minimum pressure set is reached. Then
the pressure switch re-engages the motor. The opera-
tor at the compressor should take care that the motor
engages and disengages dictated by the influence of
the increasing and decreasing pressure in the tank. The
motor engages without any previous warning.
The maximum and minimum pressure have been set in
2
the works. These settings may not be altered.
All accessories were connected to the adjustable drain
3
valve (6).
As shown on the adjustable output pressure gauge (7),
4
the pressure of the adjustable exit can be altered by
Содержание SPECIAL EDITION HC16
Страница 83: ...international 83...
