background image

TC-610H PLUS Manual

IMPORTANT SAFETY INFORMATION

WARNING:
DO NOT

 apply voltage and frequency different from those specified on voltage label at the bottom of the unit.

CAUTIONS:

1. 

ONLY

 operate the compressor in dry, well-ventilated areas on a flat surface.

2. 

DO NOT

 leave the compressor in operation unattended.

3. 

DO NOT

 insert any foreign objects into the compressor or disassemble/modify/repair it in any way.

4. 

DO NOT

 touch the compressor during or soon after operation since it will become hot.

5. 

STOP

 and turn off the compressor immediately if burnt odor, white smoke, odd noises, or other abnormalities are detected. 

    NOTE: Emission of an oil-like odor during the first few uses of a new unit is normal. The odor will gradually lessen and disappear.

Copyright © 2021 ANEST IWATA SPARMAX Co., Ltd. All rights reserved.

TC610H_PLUS_manual_20210428

1. Screw the Braided Air Hose onto the airbrush and Air Outlet. 

    NOTE: If your airbrush fitting is not 1/8” PS, select from the Aztek, Badger and Paasche airbrush adaptors included for your convenience, and screw   

    onto the airbrush and hose.

2. To connect to a 2nd airbrush, an additional hose not included is required. Remove the Outlet Cap and connect the 2nd hose. Depending on the air        

    consumption of the 2 airbrushes connected, the compressor may or may not support the simultaneous use of both airbrushes. 

www.SPARMAXair.com

This manual contains important information on the correct operation, maintenance and safety information of 
the compressor, all of which should be strictly adhered to. Failure to do so may cause damage of product 
and/or potential hazards which are not covered under SPARMAX warranty.

Each SPARMAX compressor is tested and fully inspected to ensure its quality and performance are up to strict 
standards at the time of factory dispatch.

PARTS DIAGRAM 

SET UP

Check all parts are present and in good condition. Any transportation damages should be reported immediately to the original seller.
See voltage label at bottom of unit for specifications.

Braided Air Hose

On/Off Switch

Auto Stop Pressure Switch

Air Tank Safety Valve

Plug

Airbrush Holders (2)

Pressure Regulator

Knob

Outlet Cap

Air Outlets (2)

Filter

Filter Drain Valve

Pressure Gauge

Compressor Motor

Air Tank

Rubber Stands  (4)

Handle

Air Tank Drain Valve

Отзывы: