www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
GB | 33
14. Troubleshooting
Fault
Possible cause
Remedy
Motor does not work
Motor, cable or plug defective, fuses
burnt
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
The motor starts up
slowly and does not
reach operating speed.
Voltage too low, coils damaged,
capacitor burnt
Contact the utility provider to check the voltage. Ar-
range for inspection of the motor by a specialist. Ar-
range for replacement of the capacitor by a specialist
Motor makes excessive
noise
Coils damaged, motor defective
Arrange for inspection of the motor by a specialist
The motor does not
reach its full power.
Circuits in the network are overload-
ed (lamps, other motors, etc.)
Do not use any other equipment or motors on the
same circuit
Motor overheats easily.
Overloading of the motor, insufficient
cooling of the motor
Avoid overloading the motor while cutting, remove
dust from the motor in order to ensure optimal cool-
ing of the motor
Saw cut is rough or
wavy
Saw blade dull, tooth shape not ap-
propriate for the material thickness
Re-sharpen saw blade and/or use suitable saw blade
Workpiece pulls away
and/or splinters
Excessive cutting pressure and/or
saw blade not suitable for use
Insert suitable saw blade
