www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
32 GB
All ball bearings are lifetime lubricated. The circular saw blade is a wearing part and must be checked every time before
starting up. Only a well-sharpened, correctly set saw blade delivers good cutting results. Occasional greasing of the saw
blade is recommended.
If signs of wear appear in the swivel saw slit, the swivel parts must be replaced. .
Additional maintenance work with Cardan shaft operation
Fig.5
Tightening the V-belt (Fig. 5)
• Undo the hexagonal screws and press the gear unit down
evenly. The gear unit must be adjusted parallel.
•
Tighten hexagon screws firmly.
Fig.6
Replacing the transmission oil (Fig. 6)
• Replace the transmission oil annually.
• Use SAE 90 transmission oil.
• The capacity is 0.35 litres.
•
Figure 6 shows the angular transmission oil filler plug.
• Dispose of used oil in an environmentally friendly manner.
m
Check all safety devices after maintenance and cleaning work.
Maintenance
Turn the engine off and let the engine cool down. Pull out the mains plug or remove the tractor ignition key.
Check the general condition of the machine. Be careful with loose screws, misaligned or moving parts, breakage of
parts, and any other condition that could interfere with safe operation.
Remove any foreign objects and other materials that have accumulated on the saw blade and the unit. Clean the
machine after each use. Then use a high-quality and thin fluid machine oil to lubricate all moving parts.
m
Never use a “pressure washer” to clean your unit. Water can penetrate tight areas of the machine and its
transmission case and cause damage to spindles, gears, bearings, or the engine. The use of pressure washers
will result in shortened life and reduce serviceability.
Experienced craftsmen can perform minor repairs on the machine itself.
• Check the saw blade regularly. Use only well-sharpened, crack-free and not distorted saws. Use only tools that
comply with the European standard EN 847-1.
• Exchange immediately rocker that run out.
