www.scheppach.com /
+(49)-08223-4002-99 /
+(49)-08223-4002-58
28 GB
12. Tractor attachment (at kwz 7.0 and kw-ze 7.0)
• Attach the circular saw to the 3-point hydraulics of the tractor
in a longitudinal direction and couple with the Cardan shaft for
cutting firewood.
• No persons are permitted to stand between the tractor and
attachment.
• During operation, secure the Cardan shaft with the chain to
prevent spinning.
• Switch off the tractor and remove the ignition key when leaving
the workplace.
• Hang the Cardan shaft in the holder after uncoupling from the
tractor.
• Use the correct Cardan shaft. We recommend the scheppach
Cardan shaft W110, art. no. 05018101.
13. Commissioning
• Before commissioning observe the safety notes.
•
All safety and auxiliary installations must be fitted.
•
Check the rocker, which must return to the initial position independently. Check the saw blade for perfect fit and the
correct direction of rotation.
• Functional check before start of work.
• To operate the saw, press the on / off switch. During Cardan shaft operation, start the tractor engine and the Cardan
shaft drive.
•
The saw is constructed solely for the cross cutting of firewood with max. 1 meter length.
• Regardless of the wood diameter, put only one piece with min. Ø 60 mm on the rocker.
• Use both hands to swing the rocker to the saw blade.
• Then place the rocker in the initial position.
•
The wood to be sawn must not be fixed by hand.
• After the complete standstill of the saw, pull the mains plug. During Cardan shaft operation, park the tractor and remove
the ignition key!
• Only carry out conversion, adjustment, measurement and cleaning work with the engine switched off. During Cardan
shaft operation, park the tractor and remove the ignition key!
The kw 7.0 / kwz 7.0, kw-ze 7.0 provides maximum safety thanks to its enclosed sawing area..
