Operating Instructions Booster WA 121545
18
Date: 21.09.2017
8200510 BA / EN
8.2 Meaning of the display
When the booster starts up (this is automatic when the vehicle engine starts,
D+ is then applied to the booster), the following information is displayed by
the LEDs:
F
Current charge cycle
F
Fault
F
Current charge current
The fields in the two columns with bold borders have the following meanings:
Charge
Charge current
Main charge
Risen above 1 A
The display for the charge
Full charge
Risen above 3 A
The display for the charge
current is only a rough
guide
Trickle charge
Risen above 10 A
guide.
Error
Risen above 30 A
8.3 Displaying current settings
The current settings are displayed using the 4 x 4 matrix on the top of the
device (Figure 11, Pos. 3). The top LED line specifies which value it is. The
left LED column next to the matrix shows which value is currently set.
Y
The charge current is displayed during normal operation. The following
queries are possible when the vehicle engine is running or stationary.
Proceed as follows to display the other values currently set:
"
Briefly press the ”Display” (Disp.) button -- Figure 11, Pos. 1.
F
The LED above the ”Batt. Type” column lights.
F
One of the LEDs in the left-hand column lights, e.g. the top LED.
This means that battery type ”Acid” (so lead-acid) is set.
"
Briefly press the ”Display” (Disp.) button again -- Figure 11, Pos. 1.
F
The LED above the ”Power Reduct.” column lights.
F
One of the LEDs in the left-hand column lights, e.g. the second LED
from the top. This means that characteristic C2 is set (refer to Figure
12 for more information on characteristics).
"
Briefly press the ”Display” (Disp.) button again -- Figure 11, Pos. 1.
F
The LED above the ”Max. Output” column lights.
F
One of the LEDs in the left-hand column lights, e.g the lower LED.
This means the maximum charge current can rise to 70 A.
”Batt. Type”
”Power Reduct.”
”Max. Output”
