Einstellanleitung Elektronikmotor-Studio Star_englisch.docx
Stand: 13.01.16
Seite 8 von 16
2.6. Setting Off-Mode 2 (with micro switch and switch) – For all types with box on bottom
(
Upper end position about torque detection /
set end position bottom)
Step No.
Operation
Note
Check
Important:
- First, there must always be taught the upper end position.
- If the drive switches off due to a malfunction (too fast increase of force) before reaching the endpoint, it has to be
set into learning mode again.
10
Setting the upper end position
Press UP-Button,
until the upper end position is reached and switches off auto-
matically about the torque detection. Keep pressing the button for
at least 1 sec. longer after switching off.
20
Setting the lower end position
Press DOWN-Button
until the desired position is reached. The end rod is in the area of
the end stop, the cord is not yet loose.
Moving back or moving in short impulses is allowed.
30
First press the micro switch and then the active button for ca. 2 sec. in order to learn the lower po-
sition. As a learning confirmation it twitches twice.
Attention:
Pressing the buttons not long enough the position will not be learned.
The setting mode is exited.
The learning of the forces happens automatically when running continuously from one end position to the other.
Perform this first test run only after completing all installation.
