Scantronic 4601, Инструкция по установке и эксплуатации

Страница: 4 / 12

4 of 12 496368 Issue 1
Figure 2. Setting the Site Code
Consult the sections for individual 4600 series transmitters for details
on setting the DIL switches in each transmitter.
Initial Power-Up
Note: If an SAB bell is fitted to the system and completely wired, then the bell will
ring until power is applied to the panel and bell lid closed.
1. Apply power.
2. Enter the user code 1234 to silence the internal sounder.
The panel is now in DAY mode. The walk test and other LEDs may be
illuminated but please ignore them at this stage.
To Enter Programming Mode
Make sure the Day LED is glowing before trying to enter programming mode.
1. Press 0 then Enter.
2. Key in the engineer access code (default 7890).
3. Open control panel cover to activate the lid tamper switch.
All panel LEDs start to flash. You may now proceed to program the
various system options with the panel open.
4. Fit programming stencil on control panel.
Initial Power Up 4600