Scantronic 4601, Инструкция по установке и эксплуатации

Страница: 3 / 12

496368 Issue 1 3 of 12
Wiring
Figure 1. External SAB Bell/Strobe and Internal Speaker Connections
Notes:
1. SAB shown for negative applied. The connections shown in Figure 1 are
only an example of a typical SAB module. See the bell manufacture’s instruc-
tions supplied with individual units for more information.
2. Link tamper return to 0V if no external tamper is required.
3. Connect all bell wiring to control panel with exception of the trigger to the
siren or bell. The bell/siren will continue to ring from the on-board battery until
the final connections are made after initial power-up.
Programming
Programming Detectors
A series of six DIL switches on the control panel main printed-circuit board
enables each system to be identified by means of a different code, thereby
avoiding the possibility of interference from adjacent systems. The site code
is used by the control panel and all detector/transmitters in a particular
system. Select a site code and set the six DIL switches. Carefully note the
settings of the six site code DIL switches as this code is used when setting
each transmitter/detector.
4600