Scantool COMPACT 110, Инструкции по безопасности и руководство оператора

Страница: 4 / 37

COMPACT 110
COMPACT 110
Operator’s manual for drilling machine - 4 -
9. Before attempting to work with the machine check condition of electrics including
power cord and plug.
10. The drilling machine should be connected to an installation equipped with protection
circuit (neutral or ground) and protected with a 16 A fuse for 220V and 32 A fuse for
120V.
When used on building sites, it must be supplied through a separation
transformer made in the second class of protection
11. Machine can be used outdoors, but is not weatherproof. Do not expose to rain, snow
or frost.
12. Machine should not be used on: rusty surfaces, steel plates with thick covered with
paint, uneven surfaces, next to a welding machine.
13. In all cases always use a safety chain/strap /see drawing 1/. The safety chain mustn't
be loose! To avoid this situation the safety chain should be wrapped around the
element it is hooked to.
It’s recommended to use the safety chain following the pictures
14. Do not use the machine in explosion hazard zones.
15. Do not start work if the machine has excessive play on guide slides.
16. Always wear safety goggles and ear protection.
17. Do not remove metal chips with bare hands.
18. Do not touch the spindle and the cutter during work.
Do not touch or replace the tool with power source on – while
electromagnetic base is being used.
Drawing No 1 The safety chain application