Scantool COMPACT 110, Инструкции по безопасности и руководство оператора

Страница: 9 / 37

COMPACT 110
COMPACT 110
Operator’s manual for drilling machine - 9 -
• arbor AMT4-U-19 4-3
1pc
• cooling system
1pc
• chip guard
1pc
•
spoke handles
3pcs
•
Hex. Wrench s=2,5
1pc
•
Hex. Wrench s=4
1pc
• Hex. Wrench s=5
1pc
• Hex. Wrench s=6
1pc
•
8 mm flat wrench
1pc
•
wedge, MT4
1pc
•
safety chain with snap hook
1pc
•
operator’s manual
1pc
2.1 Before first drill:
•
steel elements of the drilling machine are protected for transit and storing with grease
film. Before first start up of the machine all grease should be removed
• before each use all handles should be screwed into pinion.
2.2 Before setting the machine on an item make sure that:
- substrate is a steel and ferromagnetic (some of stainless steel or acid-proof or do not
conduct the magnetic flux);
- thickness of work piece is at least 3/8” (10 mm)
- surface of steel under the magnet is flat
- wipe, brush or sand down clean surface where you intended to place the drilling machine,
so that you remove rust, paint, dirt etc which would reduce adhesive power of the
electromagnetic base.
2.3 Preparation the machine for drilling
1. Set the drilling machine on the surface of the element which hole is to be drilled.
2. Accurately and securely attach the drill spindle in the nest (see II, point 1)
3. Plug in the drilling machine accordance to the requirements (see I point 2)
4. Set the axis of the spindle exactly over the place of drilling (the tool is over the centre of
the hole)
5. Turn the magnetic base ON
Prior to use!
Always make sure that the electromagnetic machine is secured from falling
down during vertical, ceiling work with original chain (as described in
paragraph I point 2 “Important rules of safe use of drilling machine”)
2.4 Cutting