#SC 45TW-SS 10 – 110202
Page 15 of 40
6.3. Speed Adjustment
The rotating speed for the machine could be adjusted by changing the position
of the conical turbine on its shaft. The speed will increase when lowering the
turbine and vice versa.
To change the speed, please proceed as follows:
1. Remove the inlet flange (pos. 47) by unlocking the locking plate (pos. 48)
and remove the bolts (pos. 49)
2. Loosen the contra nut (pos. 44) with key No 19 and Allen key No 4.
3. Turn the turbine to desired position and lock the contra nut.
4. The correct speed should be between 2-4 rpm ideal is 2,5-3 rpm be careful
not to screw the turbine too far down in the cone. This may cause the
machine to stop because the turbine is touching the cone.
49
48
47
44
Designer
Date
Date
Drawer
Surface treatment
Weight
Note
Dimension
Material
General Tolerances
Tolerance ISO 2768-m Gen. surface
N9
This document is our property and shall not without our permission in writing be altered, copied, used for manu- facturing or communicated to any person or company.
Drawing no. / Ritningsnr.
Format
SC45TW Nytt utf Ø9-12 mm
A4
Scale
SC45TW-S-XX
1:2
SC45TW New Ø9-12 mm
Denna handling är vår egendom och får ej utan vårt skriftliga medgivande ändras, kopieras, användas för tillverkning eller delges annan person eller firma.
SS-ISO 2768-m for machined parts
(30)-120=
0.3
0.5-3=
0.1 (120)-315=
0.5
(3)-30=
0.2 315)-1000=
0.8
P01
Törnedalsgatan 1, 275 21 Sjöbo
SWEDEN
JC
Revision
05-03-24
E
No.
Revision note
Date
Sign.
Qty.
Ins.
gram
Basic settings for turbine
Set the upper edge of the turbine
down 15 mm from
the upper edge of the
turbine cone. Then hold the turbine shaft fixed while locking the contra nut.
