Scania Interlock 5000, Инструкция по эксплуатации

Страница: 26 / 92

26 Dräger Interlock 7000
Use
3.3.2 Providing a breath sample
1. Remove the handset from
the holster.
2. If necessary, insert a new
mouthpiece into the respective
opening. When doing so,
ensure that the mouthpiece
tab is correctly aligned with the
slot in the handset (1).
3. Blow evenly into the mouth-
piece as long as a continuous
tone sounds. The blue LED
goes out when blowing begins
(only for Interlock 7000).
or
With installed camera - optional:

Hold handset with the display in the direction of the camera.

Depending on the configuration, the blue LED within the camera
may flash when the handset is recognized.

Depending on the configuration, a breath sample may only be
possible if the blue LED is flashing and the handset is recognized.

Blow evenly into the mouthpiece as long as a continuous
tone sounds.
With anti-circumvention activated (blow/suck) – optional:

Blow evenly into the mouthpiece as long as a continuous signal
tone sounds, followed immediately (the signal tone ceases)
without pause by sucking hard until a short signal tone sounds.

If the breath sample is not provided in the correct way with the blow
and suck breathing technique,
Repeat test is displayed.

Confirm with the OK button.
The instrument will request a repeated breath sample.

If the breath sample flow is too hard or too soft, a corresponding
message is displayed.

Confirm with the OK button.

The instrument requests a repeated breath sample.

After an adequate breath sample, the test result is displayed with
Test passed or Test failed .
3.3.3 Test passed
The measured breath alcohol concentration is below the set limit value.

Test passed is displayed and the LED glows green (only for
Interlock 7000).

The vehicle is cleared to start, Free Start Time is displayed and a
timer specifies how long the vehicle can be started.

After starting, the instrument is in stand-by mode and Drive Safely!
is displayed.

Attach handset to the holster again.
3.3.4 Test failed
The measured breath alcohol concentration is above the set limit value.

Test failed is displayed and the LED glows red (only for
Interlock 7000) followed by Next test in: with a timer displaying
the remaining disabled hours, minutes and seconds. The LED
remains lit until the instrument is ready to accept a further sample.

After an intermediate phase displayed via Preparing for test ,
Ready for test. Please blow is displayed.

Provide further breath samples if necessary.
00233351.eps
1