23
139234_Rev_A 9.17 .10
Surround Panel Installation
The Scan 45i 48” x 30” surround panels include a Backing
Plate and a Front Assembly with Riser Bar. This surround
package will cover fireplace openings 47 1/2” Wide x
29 3/4” High.
Fireplace openings greater than 29 3/4” high will require
substitution of the 48” x 36” Trimmable Backing Plate,
#157276.
Both types simply hang off the back of the surround
mounting brackets as in fig. 31.
Surround Assembly
1. If the Front Assembly Riser Bar is to be used, the
insert must be lifted 2” off the fireplace floor to al-
low clearance for the riser bar. See fig. 29. Install the
Leveling Brackets to achieve the appropriate height.
If the insert is installed without the riser bar option
,
you must trim off the bottom 2 inches of each leg of
the Backing Plate, or Trimmable Backing Plate. See
fig. 31. Starting at the small precut slot, use a straight
edge to draw a guideline across the leg. Use a disk
grinder to cut off the excess material and file any
burs from the raw edge.
2. Hang either the Standard or Trimmable Backing Plate
off of the back of the surround mounting brackets
shown in figs. 30 and 31.
3. Open the Controls Access Panel and hang the Front
Assembly off of the front of the surround mounting
brackets as shown in fig. 32.
Figure 29. Adjusting the Leveling Brackets.
Figure 30. Surround engagement points.
Engage Surround Panel
tabs with these slots.
Figure 32. Open the Controls Access Panel and hang the
Front Assembly on the front of the surround brackets.
Figure 31. Both the standard 48” x 30” Backing Plate and
the 48” x 36” Trimmable Backing Plate hang off the back
of the surround brackets.
Trim excess 2” if
Riser Bar is not
used.
Standard or
Trimmable
Backing Plate
Front
Assembly
Riser Bar
Leveling
Brackets
