8
SC 303/313 – 050062-101_rev- 05
>>>
c)
If there are more coins to count, press
MOTOR ON/OFF
to continue.
d)
During the counting operation, check for rejected coins and put any
valid coins back into the coin tray.
e)
If the last batch count is incomplete, indicated by the LED above
Q
not flashing, press
B
to display the number of coins in the bag (partial
batch register).
f)
To reset the partial bag register, press
B
and
CE
at the same time to
reset the partial batch register.
g)
To exit the batch counting mode, repeatedly press
Q
until the LED
above
Q
is
not
lit.
Setting a Temporary Batch Stop
a)
Press and hold
Q
while selecting the required batch number by means
of the four control panel keys (
M
,
ACC
,
B
and
CE
).
The figure
9
will appear at the far left of the display, indicating that
you are working with a
temporary
batch quantity.
b)
Release
Q
.
The machine is now ready to count the temporary batch.
c)
Proceed to count the batch as described in
, steps b to g.
Note!
This temporary batch is not stored in the memory of the machine and will
be lost when the machine is turned off or when another batch stop is
selected.
Changing a Fixed Batch Stop
a)
Press
Q
and switch on (
ON
) the machine.
b)
When the display changes from showing a row of the digit
8
, release
Q
.
The machine is now in the programming mode. The figure at the far
left of the display is the fixed batch stop reference number (
1
–
7
) and
the other figures the batch quantity (
5
–
10 999
).
c)
Press
Q
several times until the display shows the desired batch stop
reference number.
d)
Press the keys below to change the fixed batch stop quantity setting.
Every time the
M
,
ACC
,
B
or
CE
key is pressed the displayed digit(s)
immediately above the pressed key is changed.
e)
To change another fixed batch stop quantity, return to step c.
f)
When all the required fixed batch stop quantities have been changed,
press and hold
MOTOR ON/OFF
until the digit on the far left
disappears.
All of the fixed batch stop quantities are now in the memory and will
remain there also when the machine is switched off (
OFF
).
Clearing a Blocked Coin Exit
WARNING!
Risk of jamming!
Follow the
“Safety Precautions” on page 3
If a too large coin blocks the coin exit:
a)
Set the coin diameter and thickness knobs to their maximum settings.
b)
Open the right cover and manually turn the disc to get the coin
rejected when it passes over the reject chute.
c)
Reset the coin diameter and thickness knobs to their desired settings
and put any valid coins into the coin tray.
d)
Press
MOTOR ON/OFF
to resume counting.
