7
SC 303/313 – 050062-101_rev- 05
Operation
WARNING!
Risk of jamming!
Follow the
“Safety Precautions” on page 3
.
Getting Started
SC 303
RoHS
M/c No
.
012461-004
Serial No.
Assembled 201
1 in Taiwan
220-240 V
AC
50 Hz
0.2
A
Fuse F2AL
MALMÖ-SWEDEN
a)
At the rear of the machine, ensure that the mains supply lead is
connected.
b)
Set the main switch to the
ON
position.
Continuous Counting
WARNING!
Risk of tipping!
Follow the
“Safety Precautions” on page 3
.
a)
Select the proper settings for coin diameter and thickness
for the coins to be counted by using the two knobs on the
top of the machine.
b)
Pour the coins to be counted into the coin tray.
c)
Press
Q
several times until the LED above is
not
lit and
0
is displayed.
This indicates that the continuous counting mode has been selected.
>>>
>>>
d)
Press
MOTOR ON/OFF
.
The machine starts to count and the display continuously shows the
number of counted coins.
– To stop the machine while counting, press
MOTOR ON/OFF
.
– To add the number of coins counted to memory, press
M
. The
display will reset to zero and the LED above
ACC
will be lit,
indicating that there is something stored in the memory.
– To view the contents of the memory, press and hold
ACC
.
– To clear the contents of the memory, press
CE
while holding
down
ACC
.
– To reset the display, press
CE
.
e)
During the counting operation check for rejected coins and put any
valid coins back into the coin tray.
Note!
The maximum number of coins that can be displayed is 999 999. When
this value has been reached the machine will stop and the display will flash
to indicate overflow.
Batch Counting
By pressing
Q
several times the machine will display the seven fixed batch
stops sequentially.
a)
Select the required batch stop and hold down
Q
.
The selected batch stop number is displayed on the left and the batch
quantity on the right. The LED above
Q
will also be lit indicating that
the machine is in batch counting mode.
Note!
Press
B
to check that the partial batch register reads zero before starting. If
not, press
B
and
CE
at the same time to reset.
b)
Press
MOTOR ON/OFF
.
The machine will start counting and will stop when the batch stop is
reached. The LED above
Q
flashes when a full batch is reached.
>>>
