SBG GeoStar 200, Руководство пользователя

Страница: 39 / 70

Settings
Page 39/70 May 2015 I 2.0
Tap on the blue arrows to navigate to the next
step (Figure 50).
A headland alarm signal for rear and front
implements can be switched on or off. The
headland signal emanates from the reference
point of the machine (blue dot on the drawing).
Tap on the speaker icon at Headland signal to
activate or deactivate the headland signal.
When a negative value is entered at Offset ON
(Figure 50), the headland signal will be outputted
earlier while driving into the field (leaving the
headland). So, the actual signal is outputted
before the set reference point.
When a negative value is entered at Offset OFF
(Figure 50), the headland signal will be outputted
earlier while driving towards the headland (from
the field). So, the actual signal is outputted after
the set reference point.
Tip!:
By putting too large or too small values for
Offset ON and Offset OFF the potential
delay of the machine can be compensated.
Tap on the blue arrows to navigate to the next
step (Figure 51).
In this last step information for all the used
measurements of tractor and implement are
displayed.
Tap on the green checkmark key to save changes.
Tap on the red “abort” key to close this screen
without saving changes.
Figure 50 Headland signal
Figure 49 Machine offsets front implement
Figure 51 Offset info