SBG GeoStar 200, Руководство пользователя, Страница: 27 / 70

Settings
Page 27/70 May 2015 I 2.0
When recording a curve, if a corner of the field or
the end of the reference line is reached, tap on
Add corner . SBGuidance will now apply a corner
point to the last position (red pyramid on the
screen).
It is possible to alternately define straight and
curved line segments of a field by activating or
deactivating the
Record Curve key.
If a curved section has to be joined with a straight
section on the same boundary line, tap on
Record
Curve at the transition between the straight and
curved sections.
You will then be asked: “
Is this
point a corner point
?” If the straight line section
is to be joined to the curved line section, the
response to this question should be
No . This
enables a curved and straight line section of an
existing field boundary to be used as a reference
line. If the response to this question is
YES , a
corner point will be created. The curved and
straight line sections are then defined as two
different sides of the field.
Now tap on Close field in order to draw a straight
reference line from the last corner point to the first
corner point. The surface area within the defined
contour will then be calculated after closing the
field. If you have only entered a single curved
side, you do not need to close the field.
If Close field automatically is selected,
SBGuidance closes the field automatically when
the vehicle is within a radius of 5 metres from the
first corner point.
Please note!
A corner point separates two different sides
of a field. Do not add a corner point to the
centre of a side that is considered as a
whole.
Figure 28 Example of recording a combination of a
curved and straight line section
Figure 29 Example of a field