Instruction leaflet
Sight Recessed
72641
Live Voltages may be present in this unit even when turned of or when completely disconnected.
For your safety, always switch off the power supply before changing lightbulbs, or cleaning.
This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
Safety information
Cleaning Information
wash
with warm water or just use a damp cloth.
finish.
Check with your Local Authority or retailer for recycling advice.
Recycling advice
This bulb is protected by a shade. This part must be replaced immediately should the shade become
cracked or damaged. This fitting must not be used without the shade in place.
lit for the three hour period, a new battery pack may be
required.
fully discharge then reconnect to supply and allow to
charge for 24 hours.
change the battery pack as follows:
Undo the two screws holding the front diffuser in place.
Remove the diffuser and set aside.
should not be disposed of with household waste. Please
recycle where facilities exist. Check with your local
authority or retailer for recycling advice.
Replace the battery with a 3.6V 1500mAh Ni-Cd
ONLY.
Use of a different type of battery will damage the
product.
secure battery in position and then plug battery pack
connector into the PCB.
to trap any wires.
Refit the diffuser. Tighten the screws carefully to avoid
damaging the threads.
Restore power and allow to charge for 24 hours.
Battery Replacement
www.saxbylighting.com
Saxby Lighting. BH23 3PE
V2 14/02/2020
WWW.saxbylighting.com
Saxby lighting. BH17 7BY
Replace Cracked Shade
