Sawn Craft Micro F-22 Manual
Page 5
1311101 Micro F-22 Manual.docx
2.2 Wing Reinforcement Lamination
Parts Required:
o
Main Wing
o
KFm Step
1)
Lay the main wing on the table with the front-to-back vertical stabilizer location markings slot
facing up. Apply a bead of glue around the entire perimeter of the KFm Step.
2)
Press the glued side of the KFm onto the Main Wing, aligning the leading edges of both parts, and
gently slide the parts around to spread the glue evenly.
3)
Set the assembled fuse lamination aside to allow the glue to cure. If desired you can place a flat
weight (book, etc.) on top of the lamination while curing to ensure a flat assembly.
4)
Once cured, sand leading edges to your liking.
