Savant Button Remote Deployment Guide
Copyright © 2018 Savant System, LLC
009-1624-00 | 180521
5 of 14
3
REM-0300RF Equipment Overview
Refer to the Quick Reference Guide for these products located on the
Savant Customer Community
for Box Contents and Specifications.
3.1
Controller
Front Panel
Reset Button
Press
will place the device in remote pairing mode, this will turn the Status
LED red.
Press and hold
for five seconds while powered on to clear the network
settings. The Status LED blinks rapidly when reset is complete.
Status LED
Off
: No Power.
Green
: Provisioned to the local network and communicating with the Savant Pro System Host.
Blink Green Once
: In Provisioning Mode. Ready to be added to the local network.
Blink Green Twice
: Establishing connection with the local network.
Blink Green Three Times
: Connected to the local network. Is connecting to the Host.
Short Off Green Blink
: Firmware is updating.
Rapid Green Blink
: The reset button was held down for at least five seconds and the SSC-W103I is performing a
factory reset. After reset, all network settings are cleared and the factory defaults are set.
Red Blinking
: Remote pairing mode.
Rear Panel
IR
Used to send IR signals to control devices with an IR flasher
(5V tolerant only).
Input Power 5V DC 1.2A - Connect to included power supply.
Cable Lance Use with included cable tie to secure power supply connection.
