Savant REM-0300RF-00, Руководство по развертыванию

Страница: 7 / 14

Savant Button Remote Deployment Guide Copyright © 2018 Savant System, LLC
009-1624-00 | 180521 7 of 14
4 Installation
The Savant Button Remote requires the use of a Controller to allow the commands to be sent to the Host. This section covers the installation of the
Controller.
4.1 Controller
The Controller must be installed within the RF range of the Remote. Savant recommends that the Controller is installed in the same room the Remote
is going to be used in.
Mounting Plate Installation
The mounting plate available in the shipping box can mount the controller to a wall or existing structure. Follow instructions below to mount the
controller.
1. Place the mounting plate onto a wall so the tabs that hold the controller are oriented horizontally.
2. Mark on the wall the two mounting holes. Install wall anchors and screw the mounting plate to the wall.
3. Snap the controller into the bracket so the tabs on the bracket seat into the slots on the side of the controller.
Rack or Cabinet Installation
When mounting in a rack or cabinet, the controller should be set on a solid, flat, level surface.
Controller Provisioning
For instructions and information about provisioning the SSC-W103I please review the SSC-W003I/SSC-W103I Deployment Guide on the Savant
Customer Community.
4.2 Remote Pairing
After batteries have been installed in the Remote, to pair the Remote to the Controller do the following.
1. Press the reset button on the Controller and Status LED will start Blinking Red.
2. On the Remote press and hold the Up Arrow and Select buttons on the Navigation (D-pad).
3. When the binding is successful the Status LED on the controller will return to its last state.