TO-BA-e-2020
11
4
Operation
4.1 Power supply
Two AA alkaline batteries are required as power supply. The battery compartment is
located at the rear. The cover is fixed with two screws. To insert the batteries:
➢
Loosen the two screws of the battery cover.
➢
Lift the cover upwards.
➢
Insert the batteries into the battery compartment.
➢
Close the battery compartment and tighten the screws.
➢
Turn on the power to ensure that the batteries are inserted correctly and securely.
4.2 Connection of the probe
To prepare the instrument for operation, you must connect a probe to it. The instrument
is equipped with the Lemo sockets.
When connecting a probe to the instrument, it is not only important that a physical
connection is properly established. It is also important that the instrument is properly
configured to work with the installed probe.
4.3 Switching on the device (Power ON)
To start the unit, press the key
until the display is activated. While the unit is starting
a start-up screen, the display shows the serial number of the unit, the installed software
version, the date and time of the system.
The initial screen of the machine appears as shown in the following figure:
Press the F1 key to switch to another language.
Press the F3 key to skip the boot check procedure and immediately switch to the
measuring mode.
The instrument carries out a self-test and then automatically switches to the measuring
mode if no further key is pressed.
The instrument is now ready for the first measurement.
The device automatically reloads the last settings. It has a special memory in which all
settings are retained even when the power supply is switched off.
