sauter FL, Инструкция по эксплуатации

Страница: 13 / 21

FL-BA-e-2020 13
9
Computer control of the force gauge
With the RS 232 interface a connection from the force gauge to the PC can be
established by sending RS232 commands.
RS232 command Action
"„m“
Change measuring mode
"„u“
Change measuring unit
"„z“
Set device to "zero
"„r“
Perform reset on the device
10
RS232 output signal
The reading of the FL shown on the display can be transferred to the PC by pressing
the PRINT button or by issuing a command instruction to the force gauge from the
PC.
RS232
command
Action
"“l”
Send the direct reading with unit
"“p”
Send peak value (on pull) with unit
"“c”
Send peak value (on pressure) with unit
"x" or
pressing
PRINT KEY
- Send the direct reading with unit if the current mode is
the track mode
- Send peak value (on pull) with unit if the current mode
is peak mode
- Send peak value (on pressure) with unit if the current
mode is the peak value print mode
"“d”
Send save
"“!”
Send information about the device such as model,
capacity, serial number, firmware check, original offset,
current offset, overload counter