Step 11
422191
www.sauder.com/services
Page 15
A
E
å
Turn four BLACK 9/16" FLAT HEAD SCREWS (32S) into the RIGHT END (A) and RIGHT UPRIGHT (E) until the shoulders
of the SCREWS rest on the surfaces of the END.
å
NOTE: Do not overtighten the SCREWS.
å
Slide the RIGHT END MOLDINGS (K) onto the RIGHT END (A) and RIGHT UPRIGHT (E). Line up the grooves in the
MOLDINGS over the heads of the SCREWS in the END and UPRIGHT.
å
NOTE: The MOLDINGS should be even with the top edges of the END and UPRIGHT.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
BLACK 9/16" FLAT HEAD SCREW
(4 used in this step)
32S
K
K
Apply pressure toward the END with
your hands as you guide the MOLDING
over the SCREWS and onto the END.
Apply pressure toward the UPRIGHT with
your hands as you guide the MOLDINGS
over the SCREWS and onto the UPRIGHT.
Shoulder
The groove should be against
the END and UPRIGHT.
Shoulder
