SATO CT 412i, Руководство оператора

Страница: 58 / 73

Unit 4: Printer Configuration
CT4i Operator’s Manual
4-21
4.10 PRINTING FACTORY/SERVICE TEST PRINTS
The Factory/Service Test Label prints the internal operating parameters of the printer.
1. Release the print head. (see “Releasing/Replacing the Print Head on page 4-4).
2. Press the LINE and FEED buttons while turning the printer ON.
3. When the printer beeps, release the LINE and FEED buttons. The printer will then beep 3 times indi-
cating it is in the Factory/Service Print Test mode.
4. Re-latch the Print Head.
5. Press the LINE button to print a large (4" wide") Factory/Service Test Label. Press the FEED button
to print a small (2" wide) Factory/Service Test Label.
6. The printer will begin printing a series of test labels, the first containing the operational parameters of
the printer followed by one containing the internal printer settings. These two label formats will alter-
nate until the FEED button is pressed, suspending the print operation. If the FEED button is pressed
again, the printing will resume.
To remove the printer from the Factory/Service Print Test mode, remove power by placing the POWER
switch in the OFF position.
Note:
Depending on the version of your printer’s onboard software, the appearance of your test
printout may be different from that shown here.